Electronic accessories
Replacement fuses
Posi-Tap branch connector set of 6
Content: 6 Piece(s) (€1.66 / 1 Piece(s))
Flasher Relay R1
Micro relay for the pros The R 1 flasher relay has very small dimensions and flashes independently of load at a steady 75 pulses per minute. It also has a connection available for the flasher dashboard light. It is easily installed into the feed to the indicator switch, or can be swapped with the original 2-3 pole flasher relay. It is therefore suitable for all motorcycles with indicator switches. Should the change to LED indicators result in the non-intentionally activated indicators also flashing; then the indicator control light must also be connected to the R 1 relay. The ‘hazard warning’ effect will then be effectively All necessary components required for installation are included. ECE-tested Simple installation in feed to the indicator switch or swap the original 2-3 pole flasher relay Connection to indicator control light also possible Restricts the accompanying flashing of non-activated indicators Load-independent / steady flash rate Switching capacity 0-50W by 12V/ 0-24W by 6V Very small dimensions 22 x12 x 6 mm (L/W/H) Suitable for indicator switches Suitable for 6 and 12 volt DC applications
i.SED V6
i.SED V6 suitable for vehicles with 5-9 volt indicator application For example when mounting indicators with higher wattage than original indicators with higher voltage than original indicators on vehicles where the ground is „plus“ but not „minus“ as usual
i.SED V12
i.SED V12 suitable for vehicles with 12 volt indicator application For example when mounting indicators with higher wattage than original indicators on vehicles where the ground is „plus“ but not „minus“ as usual „DF“ products on vehicles where the indicators ground is switched but not the plus as usual
i.SED - Performance
i.SED - Performance i.SED - This performance accessory secures a continuous power supply only when the ignition is switched on. Any quiescent currents will be eliminated. Suitable for all products with particularly high power, e.g. Jetstream indicator, Jetstream DF and Dayron PL. Easy installation Continuous power supply only when ignition is switched on Ilimination of quiescent currents Trouble free operation of all Kellermann Jetstream products
Flasher Relay R2
The Classic The load-independent R2 flasher relay is the universal problem solver when using LED and halogen indicators. It replaces all original 2-3 pole flasher relays and delivers a constant and correct flashing frequency. Connection is simple. If following the conversion to LED indicators, the non-activated indicators also flash, then all that is required is for the relay to be connected to a left and a right indicator in order to reliably cure this problem*. All necessary components required for installation are included. * In certain cases the hazard warning flasher facility must be deactivated. ECE-tested Replaces the original 2-3 pole flasher relay Restricts the accompanying flashing of non-activated indicators Load-independent / usual flash rate Switching capacity 0,5-85 watt Small dimensions 34 x 22 x12 [mm] (L/W/H) High quality metal housing Suitable for indicator switches Suitable for 12 volt DC applications