Micro relay for the pros The R 1 flasher relay has very small dimensions and flashes independently of load at a steady 75 pulses per minute. It also has a connection available for the flasher dashboard light. It is easily installed into the feed to the indicator switch, or can be swapped with the original 2-3 pole flasher relay. It is therefore suitable for all motorcycles with indicator switches. Should the change to LED indicators result in the non-intentionally activated indicators also flashing; then the indicator control light must also be connected to the R 1 relay. The ‘hazard warning’ effect will then be effectively All necessary components required for installation are included. ECE-tested Simple installation in feed to the indicator switch or swap the original 2-3 pole flasher relay Connection to indicator control light also possible Restricts the accompanying flashing of non-activated indicators Load-independent / steady flash rate Switching capacity 0-50W by 12V/ 0-24W by 6V Very small dimensions 22 x12 x 6 mm (L/W/H) Suitable for indicator switches Suitable for 6 and 12 volt DC applications
The Classic The load-independent R2 flasher relay is the universal problem solver when using LED and halogen indicators. It replaces all original 2-3 pole flasher relays and delivers a constant and correct flashing frequency. Connection is simple. If following the conversion to LED indicators, the non-activated indicators also flash, then all that is required is for the relay to be connected to a left and a right indicator in order to reliably cure this problem*. With vehicle specific plug, suitable for many Kawasaki models. ECE-tested Replaces the original 2-3 pole flasher relay Restricts the accompanying flashing of non-activated indicators Load-independent / steady flash rate Switching capacity 0,5-85 watt Small dimensions 34x22x12 [mm] (L/W/H) High quality metal housing Suitable for indicator switches Suitable for 12 volt DC applications
The Classic The load-independent R2 flasher relay is the universal problem solver when using LED and halogen indicators. It replaces all original 2-3 pole flasher relays and delivers a constant and correct flashing frequency. Connection is simple. If following the conversion to LED indicators, the non-activated indicators also flash, then all that is required is for the relay to be connected to a left and a right indicator in order to reliably cure this problem*. All necessary components required for installation are included. * In certain cases the hazard warning flasher facility must be deactivated. ECE-tested Replaces the original 2-3 pole flasher relay Restricts the accompanying flashing of non-activated indicators Load-independent / usual flash rate Switching capacity 0,5-85 watt Small dimensions 34 x 22 x12 [mm] (L/W/H) High quality metal housing Suitable for indicator switches Suitable for 12 volt DC applications